Search found 3 matches

by wgollie434
Fri Apr 11, 2014 6:35 pm
Forum: Discussion
Topic: Whichever it be
Replies: 7
Views: 915

Re: Whichever it be

The whole Z-axis goes down
by wgollie434
Fri Apr 11, 2014 3:26 pm
Forum: Discussion
Topic: Whichever it be
Replies: 7
Views: 915

Whichever it be

I am not quite sure where to post this, so here goes: I have Shapeopko V2, Audrino Uno, Grbl Shield 3. Sometimes when I am cutting a project out, the Shapeoko starts to drill to china. That is the bit goes down. For no reason it does this. It can do it on a job that I have ran before successfully. S...
by wgollie434
Fri Oct 11, 2013 7:20 pm
Forum: Discussion
Topic: Shapeoko or Grbl error
Replies: 2
Views: 522

Shapeoko or Grbl error

I an running with a synthetos V3 grblShield. I am not sure where the problem may be but here goes. Whenever I draw a something or mill it never completes the circle, square letter etc. There is always a small space remaining. I also get errors in my gcode. The errors are flaged by the sender I use. ...