The Shapeoko Forum

Hello, machine sells there yet?

Hello,
Sold Is the machine?

My new Z-axis and static dust collector

Everything is checked,but the machine is not mooving.I will clear EEPROM and manually restore setting(thanks WillAdams) Is it necessary to insert or change value of startup block?When i try to manually mooving,GRBL controller send error there is no set value for default feed [G0 G54 G17 G21 G90 G94 ...

Hello,
Serial port setting for 0.9 - 115200.As back again 0.8,no problem.If upload 0.9i machine freeze and no moving.

Hello,I change electronic on my shapeoko.With the old electronics from Shapeoko(Arduino and gShield) made laser engraving machine. When use grbl 0.8,machine working fine,not any problems.If upload grbl 0.9i(SO2 default) for use Laser engraving software macine stopped and not moving. Where is my erro...

This is my machine:
I work with laptop and want USB driver board working with dual motor for Y-Axis.My Nema 23 does not work well with gShield.

Recommended for me driver board or change Nema 23 with Nema 17!

lioramsalem wrote:it has 4 drivers so I don't see why no.
In Mach3 you can slave one motor to the other and I'm pretty sure it's the same on other software..

LA

What electronics use for you machine?

Hello,
Is possible use and config this driver board:
http://www.ebay.com/itm/261491784208?_t ... EBIDX%3AIT
for working whit ShapeOko and dual Nema 23 stepper motor on Y-Axis?

Hi, I have the same problem.My gcode for 3Dfinishing is about 72000 row.During operation, the machine stops working and send messages Sned G-Code filed. Material size is 160 x 160 mm. 1.png Code generated my friend from Aspire with Shapeoko_PostP_mm. Where is my error and how can the problem be solv...