Search found 3 matches

by okalkan
Tue Apr 22, 2014 2:18 pm
Forum: PCB Fabrication
Topic: Failed! PCB milling not satisfying yet ...
Replies: 7
Views: 1896

Re: Failed! PCB milling not satisfying yet ...

Update: Thanks to Timothy for the inspiring description. I will also use your ideas on wiring, cause it looks much better than mine yet. Concerning PCB milling: I tested some more and figured out two major reasons: Reason 1: a "not perfect" dremel tool - which wobbles in it's axis a little bit which...
by okalkan
Thu Apr 17, 2014 5:49 pm
Forum: PCB Fabrication
Topic: Failed! PCB milling not satisfying yet ...
Replies: 7
Views: 1896

Re: Failed! PCB milling not satisfying yet ...

Thanks for your answers.

For the next try, I will do:
- use a reduced depth
- try multi pass
- use a higher speed
- use clamps instead of double sided tape

Best regards,
Ove
by okalkan
Thu Apr 17, 2014 12:54 pm
Forum: PCB Fabrication
Topic: Failed! PCB milling not satisfying yet ...
Replies: 7
Views: 1896

Failed! PCB milling not satisfying yet ...

Hello everyone, beside the impressing results of successfull milling results as documented in the forum, here's a not yet satisfying result. Setup: Shapeoko 2 as sold as complete set from inventables. Engraving Bit: Aptec 30°, 0.1mm Milling Bit: 0.8mm Rotary Tool: the one shipped with the Shapoko 2 ...