Search found 6 matches
- Fri Aug 15, 2014 12:47 pm
- Forum: tinyG
- Topic: Help with TinyG
- Replies: 1
- Views: 639
Help with TinyG
Hi I have setup my shapeoko2 with Nema 23 upgrade for all axes, hookup tinyg, using TGFX, but each time i tried to run a job, it randomly stop without finishing the job, sometimes the Z axes will plunge thru the stock, however when i used openscam i can see the toolpath was ok. Does anyone know what...
- Sun Jul 20, 2014 4:19 am
- Forum: tinyG
- Topic: How to Update settings?
- Replies: 14
- Views: 3348
Re: How to Update settings?
Hi, I have a Shapeoko2 upgraded to Nema 23 stepper (from Inventables) on X, Y and Z axis(Z axis ACME upgrade from Improbable Construct), I am using TinyG with TGFX, does anyone know what is the setting configuration for TGFX? I am trying to assemble a E stop from Inventables, does anyone know where ...
- Thu Jun 26, 2014 12:45 pm
- Forum: GRBL
- Topic: Commands too long
- Replies: 13
- Views: 4205
Re: Commands too long
Hi, just delete the spaces and it will be 50, it seem only this line always more than 50, it works so far until someone can come up a alternative or permanent solution.
- Fri May 23, 2014 10:10 am
- Forum: Assembly
- Topic: The Tap kit doesn't work
- Replies: 46
- Views: 6077
Re: The Tap kit doesn't work
Just a suggestion, why don't the kit come pre Tapped? to solve this problem
- Fri May 23, 2014 10:06 am
- Forum: Assembly
- Topic: The Tap kit doesn't work
- Replies: 46
- Views: 6077
Re: The Tap kit doesn't work
Hi just got my full kit, and I can confirm the tap handle definitely wrong size, no matter what I do the bits and the tap handle doesn't fit at all, could anyone tell me what kind of bits needed to do this tap? so i can buy 1 from the hardware store.
- Sun May 18, 2014 2:20 pm
- Forum: Assembly
- Topic: Flange bearing assembly
- Replies: 5
- Views: 937
Flange bearing assembly
Hi,
Just got my Shapeoko 2. was trying to assemble the Flange Bearing to the top Z axis Motor Mount plate, i just can't get it into the hole, anybody can help? Tks
Just got my Shapeoko 2. was trying to assemble the Flange Bearing to the top Z axis Motor Mount plate, i just can't get it into the hole, anybody can help? Tks