Search found 6 matches
- Mon Jul 17, 2017 4:08 pm
- Forum: GRBL
- Topic: SO2 Issue with GRBL and X Axis Motor
- Replies: 4
- Views: 963
Re: SO2 Issue with GRBL and X Axis Motor
Thanks for the info. I did have some time yesterday and adjusted the pot and got it somewhat working off and on. If the board was friend would it be totally gone or would it possibly work off and on? Also just out of curiosity, does it seem like anyone is still messing with ramps? I saw a few old po...
- Sun Jul 16, 2017 8:14 pm
- Forum: GRBL
- Topic: SO2 Issue with GRBL and X Axis Motor
- Replies: 4
- Views: 963
SO2 Issue with GRBL and X Axis Motor
So I had my shapeoko 2 all set up and finally got my DIy brushless spindle working okay. I've made a few projects and everything was working okay. I haven't used it in a while and last night was planning on cutting some acrylic. Got the piece mounted and booted up the computer. Once GRBL fired up, t...
- Sat Jun 06, 2015 4:31 pm
- Forum: GRBL
- Topic: Fried Driver Board
- Replies: 2
- Views: 587
Re: Fried Driver Board
Thanks. Wires seemed to be okay, but I'm going to check it out today and see if I can track down the issue.
- Sat Jun 06, 2015 2:04 am
- Forum: GRBL
- Topic: Fried Driver Board
- Replies: 2
- Views: 587
Fried Driver Board
I had my stock S02 running okay and was trying to get it dialed in. I was running a project today and had some kinda issue and had to abort the project. When I reset everything the X axis is now making noise and lighting up even when the computer is not connected to the board. I thought it was an is...
- Fri Mar 20, 2015 4:21 pm
- Forum: MakerCAM
- Topic: Pocket from the center?
- Replies: 1
- Views: 1182
Pocket from the center?
Is there a way to change the tool path in makercam to work in reverse? For example to take a roughly pre drill piece of material and the use a pocket to open up the hole to the correct size, starting each new layer from the pre drilled center hole, instead of working outside in? Hope that makes sense.
- Sat Nov 29, 2014 11:18 pm
- Forum: Discussion
- Topic: Grrr... Guess I should have waiting a couple of days.
- Replies: 3
- Views: 896
Grrr... Guess I should have waiting a couple of days.
Looking forward to my kit getting here, but sure which I would have know it was going on sale today... oh well... Still looking forward to the putting it to use.