The Shapeoko Forum

Ok I found the problem. The bearing on the included flange is damaged. The metal seal in the bearing is deformed like the press used to seat it was off center

not using the shim washer. Ill take some measurements and post some pics when i get home

I'd thought that the instructions include trimming off the excess length? I know I had to do that on one end of my upgrade for my SO1.

The problem isnt the machined ends length. The problem is that the fully threaded part appears to be too long

Hello IC, I received my upgrade kit last night and I seem to have a problem. It appears the machined ends on the jack screw are a bit too long. When i assemble the top and bottom brackets (bearing flanges both pointing towards each other) that the brackets arent parallel. for example if it tighten t...