Search found 6 matches

by baccck
Sun Feb 15, 2015 4:47 am
Forum: Software - CAD, CAM, Workflow Help
Topic: Easel Problems?
Replies: 5
Views: 612

Re: Easel Problems?

I did a quick and simple test in makercam and It seems that if I do a software reset and reset home before I run a program I get good results.
Is that normal?
I'll give my easel design another try tomorrow.
by baccck
Sun Feb 15, 2015 1:35 am
Forum: Site Suggestions
Topic: wiki edit - First Job section
Replies: 2
Views: 535

Re: wiki edit - First Job section

IIRC I was just looking for various posts on calibration suggestions and wound up there to go through the hello world sketch again.
by baccck
Sun Feb 15, 2015 12:05 am
Forum: Software - CAD, CAM, Workflow Help
Topic: Easel Problems?
Replies: 5
Views: 612

Re: Easel Problems?

So something is messed up. Need to take a few steps back I think. I decided to re-calibrate and the X and Y were off a bit (ran straight lines to middle of board from home and then adjusted based on how much offset). Then once I had both x and y calibrated individually I ran G21 G91 G1 X150 Y150 F80...
by baccck
Sat Feb 14, 2015 9:07 pm
Forum: Site Suggestions
Topic: wiki edit - First Job section
Replies: 2
Views: 535

wiki edit - First Job section

I am new so I can't PM wikiadmin to get a login to edit the wiki.
Sooooo....hoping someone with access can change this:

In the "Go!" section on page http://www.shapeoko.com/wiki/index.php/ ... _First_Job it says the invert mask is $7 but it is actually $6
(see attached pic)

Anna
by baccck
Sat Feb 14, 2015 8:28 pm
Forum: Software - CAD, CAM, Workflow Help
Topic: Easel Problems?
Replies: 5
Views: 612

Re: Easel Problems?

Hi clockit, I got the hello world to work with a stiff felt tip..took a bit but got it to the point that the only issues seemed to be from slack due to the who the pen was fixed into place. IIRC the only change was the step port invert mask and I can't recall why that change was made. I thought a go...
by baccck
Thu Feb 12, 2015 11:25 pm
Forum: Software - CAD, CAM, Workflow Help
Topic: Easel Problems?
Replies: 5
Views: 612

Easel Problems?

Just starting out with my brand new Shapeoko 2, using easel to test it out. The problem is that the image in easel does not match what the Shapeoko is putting out, for example, I made a simple rectangle that is 2.471" x 0.523", instead what I got was 2.3125" x 0.4375". The rectangle was also suppose...