Search found 7 matches

by GrainGuy
Wed Nov 11, 2015 1:16 am
Forum: Discussion
Topic: final code missing
Replies: 1
Views: 333

final code missing

I have a shapeoko 2 with grbl 9 and use vcarve pro. Around the time I upgraded to grbl 9 I noticed ugs and grbl controller would continue to run after my spindle would park. I think its not writing or reading the final gcode command. Could this be a problem with vcarve, post processor, or grbl? Any ...
by GrainGuy
Sun Mar 08, 2015 9:21 pm
Forum: GRBL
Topic: UGS and grbl controller freeze
Replies: 11
Views: 1690

Re: UGS and grbl controller freeze

I changed everything back to my original setup and all is good. I will worry about getting the printed pla setup to work another day. Thanks for everyones insight.
by GrainGuy
Sun Mar 08, 2015 2:30 am
Forum: GRBL
Topic: UGS and grbl controller freeze
Replies: 11
Views: 1690

Re: UGS and grbl controller freeze

Yeah man, the only thing Ive done different is adding the new mounts and dust shoe printed from pla. Ive always had dust collection, but both it and the mounts for my dw611 were made from wood. Im going to swap things back for now and see how that does. Thanks fellas.
by GrainGuy
Sat Mar 07, 2015 10:20 pm
Forum: GRBL
Topic: UGS and grbl controller freeze
Replies: 11
Views: 1690

Re: UGS and grbl controller freeze

This is making me crazy. My dust collector has a ground. I ran a ground at the mount to some ductwork. Im still not able to get through a run. Is there a better place to ground it? I also tried booting up my raspberry pi with grbl controller and no luck.
Thanks for all your input.
by GrainGuy
Sat Mar 07, 2015 5:22 pm
Forum: GRBL
Topic: UGS and grbl controller freeze
Replies: 11
Views: 1690

Re: UGS and grbl controller freeze

I just printed a new mount for my spindle and attached my hose and dust shoe to the gantry. Could this cause static and jack everything up? How do I get a pic on here for ya to see?
by GrainGuy
Sat Mar 07, 2015 1:47 pm
Forum: GRBL
Topic: UGS and grbl controller freeze
Replies: 11
Views: 1690

Re: UGS and grbl controller freeze

Thanks for the reply Will. I have everything on different circuits. If I get a anti-static strap where should I put it? I will pick up a usb cord. Now that I've had a good nights sleep and the pain of defeat has worn off, Im wondering if my usb ports are going bad in my computer. Its an old computer...
by GrainGuy
Sat Mar 07, 2015 4:28 am
Forum: GRBL
Topic: UGS and grbl controller freeze
Replies: 11
Views: 1690

UGS and grbl controller freeze

My Shapeoko 2 has been running great for months. Today it decides to stop mid path, over and over again at different points each time. I have changed out the USB cord ( & reroute away from everything else), tried other USB ports,unhooked 24v fan, isolated power to gshield, tried grbl controller ( in...