The Shapeoko Forum

My bad, after checking into the G code files, plunges when cutting tabs are indeed performed at plunge feedrate...

Hi, I am using fusion 360 + chilipeppr to operate my cnc router. I didn't look into into my g code files but I'm pretty sure that cutting tabs is performed at full feed rate, even when plunging and retracting. Do you confirm this ? Is there any settings in fusion 360 to set a lower speed when plungi...

Ok, thanks for your responses.
I will consider the idea of pendants.

Does anyone knows if it is possible to wire buttons for feed hold and resume?
After some searches I could not find any information on that.

check that the Y pulleys are correctly tightened on the motor shafts.

thanks for your answers.

I think that I will end with that kind of solution

Hi all,
Does anyone know where I can source flexible brush strip for my dust shoe in Europe (ideally France)?
After several searches, I only find that kind of stuff on US websites (like for example on kentCNC) and the shipping cost is higher than the price of the brush itself...

Thanks

You can also consider the OX cnc which I think is stiffer than SO2 or eShapeoko.
http://ooznest.co.uk/OX-CNC-Machine

Has someone a feed back on this ox cnc and maybe a comparison with the SO3?

ok thanks for this answer.
that is what I thought. Just wanted a confirmation.
By the way Nema 23 with dual shaft and same characteristics are really hard to find. So I will go for the classic one.

Thanks will. I finally found a way to get the SO3 motors cheaper than the ones with 400 steps, so this is not an issue for me anymore. Do you think that having the Z motor with a knob at is back is a really worth it feature? The SO3 does not have this kind of feature but most of the SO2 builds have ...