The Shapeoko Forum

I downloaded the latest software but when I try to open my DXF files i get an error.
Is this a bug?

up up

Moving in 10 days....keep it or sell it?...

update on the Rockwell Jigsaw Table. It is nor $99 and comes with a wall mounting kit. The web site says limited time....who knows. I love my table! https://www.rockwelltools.com/en-US/BladeRunner-X2-RK7323-SS.aspx?trk_msg=8OSIK8LT25VKJ7FHNKNE71GAJG&trk_contact=LBD1NR7OOC261FBRU479BGS66O&utm_source...

up!
now with new Z axis plate, a few extra end mills, new .750 bit for work leveling

http://www.shapeoko.com/wiki/index.php/Materials#Engraving http://www.shapeoko.com/wiki/index.php/Home/Limit_Switches#Probe The one aluminum engraving job I did I used a fixture so as to ensure a level area for the stock. http://www.shapeoko.com/projects/project.php?id=154 I did the same. I have a ...

I started to practice with engraving last night on aluminum. I leveled the work surface and screwed in a piece of .080 aluminum. First attempt was it started to engrave then started cutting 3" above the work surface. Never went back down to the material. Started over this time it cut on the material...

Got my new plate installed tonight. It's a lot nicer for sure! Took about 45 minutes to do the swap. I took off the vertical alumium rail so I could get the z plate in, then slide this in and then fought with the screw on the bottom for awhile. I also did fight with the belt for a good 15 minutes as...

Bonch,
thanks for the tip on the bit, it's amazing. Just did 2 passes .030 each pass on a 12"x7" area at 60ipm and speed 5 on the dewalt. Worked perfectly and I think I can actually go a lot faster but no rush. Cleared that area, both passes in under 7 minutes.

Just curious, what is cost on the dewalt?