The Shapeoko Forum

Can you tell me how the spindle rpm is controlled .
Jeff

Was there any modifications you had to do for it to fit on the router plate.
and does the collett fit imperial shank size bit ok.

Do you have the spindle hook up and have you used it to cut out something. What made you buy this spindle.
Jeff

Where did you get the spindle
Jeff

My thoughts on the touch prob you will love it after you figure out how to use it. I found that there are not any good video on how to use it if you are doing too changes. Also There is nothing said about what happens to the Z height if you use double sided tape. What do you plan on cutting with you...

tim614
Did you get your unit put together ok and are you up and cutting things.
Jeff from grove city.

Hi have a question Because on the XXl you can cut 32" wide. By adding a piece of mdf to your spoil board you can lay a long piece of wood say 72" long by 30" wide on top. I could cut base cabinet sides 2 at a time. Or top cabinets say 42 tall. Cutting dados for the bottom rabbit for the back and hol...

After I set the xyz and then do a tool change it is ok to move the router to another location and raise it to change the bit then set the probe on top of the wood and do the Z probe?
Jeff

Will when I do a tool change and use just the Z prob with the block on top of the wood and it does it's thing do I need to click on a zero button on the screen. Or does it set it automatically
Jeff

Tim good morning was wondering if you got you unit assembled ok and are you cutting things.
Where about's in Columbus do you live
Jeff