Search found 3 matches

by klaus-de
Fri Jul 28, 2017 7:55 pm
Forum: GRBL
Topic: Invalid gcode ID:33: Motion command target is invalid
Replies: 8
Views: 2096

Re: Invalid gcode ID:33: Motion command target is invalid

Now it works fine! chamnit: if your starting position is not on the arc within a certain range that is depending on radius and a fixed error bound I learned that it is not possible to run this command stand-alone because it can only run at a valid staring position. chamnit: You can check for gcode ...
by klaus-de
Wed Jul 26, 2017 7:53 am
Forum: GRBL
Topic: Invalid gcode ID:33: Motion command target is invalid
Replies: 8
Views: 2096

Re: Invalid gcode ID:33: Motion command target is invalid

Thanks for your reply, Dan. In my case: The error occurs even if i reset grbl/ugs and send only the command: G2 X 2.525 Y 4.034 I 0.640 J 0.640 F15 grbl will not move and return the error 33. That happens to all of these G2 X Y I J commands. Maybe they are wrong calculated .. Is someone able to veri...
by klaus-de
Tue Jul 25, 2017 7:23 pm
Forum: GRBL
Topic: Invalid gcode ID:33: Motion command target is invalid
Replies: 8
Views: 2096

Invalid gcode ID:33: Motion command target is invalid

Hi there! I am using Grbl 1.1f & UGS 2.0. When I send the following command: G2 X 2.525 Y 4.034 I 0.640 J 0.640 F15 I get: error: Invalid gcode ID:33: Motion command target is invalid. Visualize function & simulation with CAMotics works fine! Additionally: The given gcode command is one of a gcode ...