Search found 11 matches

by BrianThorkild
Fri Mar 07, 2014 10:57 pm
Forum: Discussion
Topic: Stepper motor increments
Replies: 2
Views: 538

Re: Stepper motor increments

Thank You , that was exactly what I needed.
:D
by BrianThorkild
Fri Mar 07, 2014 8:30 pm
Forum: Discussion
Topic: Stepper motor increments
Replies: 2
Views: 538

Stepper motor increments

Can I change the precanned increments for the motors?
I assume it is in the GRBL hex file?
Thanks
by BrianThorkild
Fri Feb 15, 2013 8:24 pm
Forum: Electronics
Topic: Dual Motors of one driver.
Replies: 27
Views: 10172

Re: Dual Motors of one driver.

Thanks BrianH
Your method for the motor wiring worked like a champ.
Thanks :D
by BrianThorkild
Thu Feb 07, 2013 11:20 pm
Forum: Lounge
Topic: Arduino , grblshld and 2 motors and stuff
Replies: 3
Views: 1043

Re: Arduino , grblshld and 2 motors and stuff

awesome, can't wait. already bought the dual drive kit. Very nice.
Do you have a time estimate? not pushy just eager!
by BrianThorkild
Thu Feb 07, 2013 2:36 am
Forum: Lounge
Topic: Arduino , grblshld and 2 motors and stuff
Replies: 3
Views: 1043

Arduino , grblshld and 2 motors and stuff

Is it possible to buy the electronics for a shapeoko IE:
Arduino, cable, the grblshield , power supply , two motors and cables for those. All from Inventables as an item?
by BrianThorkild
Tue Jan 22, 2013 1:25 am
Forum: Discussion
Topic: Dual Drive Kit?
Replies: 31
Views: 5831

Re: Dual Drive Kit?

Has this gone anywhere?
I am making the assumption this is for the other side of the "Y" right?
I would be very interested. :)
by BrianThorkild
Thu Jan 17, 2013 12:00 am
Forum: PCB Fabrication
Topic: Visual alignment mod for shapeoko
Replies: 51
Views: 25461

Re: Visual alignment mod for shapeoko

The entire thing is very impressive. Using the MakerSlides the way you did for clamping is awesome! I really am very interested in what code you used to even make the PCB? I have Eagle and tried some of the plugins, Not really very good. I tried "Linegrinder" just dies every time. Any ideas. I am go...
by BrianThorkild
Wed Jan 09, 2013 2:24 am
Forum: Discussion
Topic: Smallest mill bit for PCB work
Replies: 1
Views: 632

Smallest mill bit for PCB work

Where can I get a bit for doing PCB work?
by BrianThorkild
Thu Jan 03, 2013 8:30 pm
Forum: GRBL
Topic: Arduino works gsender and other stuff does not
Replies: 4
Views: 973

Re: Arduino works gsender and other stuff does not

Tom:
That was it!
I have run the "air program"
AWESOME>
Thank you so much! :D :D
by BrianThorkild
Thu Jan 03, 2013 7:48 pm
Forum: GRBL
Topic: Arduino works gsender and other stuff does not
Replies: 4
Views: 973

Re: Arduino works gsender and other stuff does not

Ok I downloaded the XLoader, it required me to install .NET. I did and the XLOADER comes up. I selected Com4 , which is the UNO. The default BAUD is 115200. Is that right?
Anyway the Hex file will be what?