Search found 2 matches

by lmwilco1
Wed Jul 17, 2019 12:09 am
Forum: Electronics
Topic: Shapeoko Control
Replies: 2
Views: 660

Re: Shapeoko Control

I think it gives me what I want. The picture below show gnd, pwm, D13, and 5v, pwm and D13 are the pins that grbl supports. It sounds like the only complexity will be getting the D13 pin not to toggle on reboot. I will see what it takes to get this going. Louis https://wiki.shapeoko.com/images/1/16/...
by lmwilco1
Mon Jul 15, 2019 3:05 am
Forum: Electronics
Topic: Shapeoko Control
Replies: 2
Views: 660

Shapeoko Control

Hello, I purchased a Shapeoko XXL in December and have been making all sorts of stuff. I have a SuperPID then I need to get connected and I figured I should do all of my connections for everything at once so I don't have to disassemble the controller board again. I want to connect up the following: ...