Search found 2 matches
Search found 2 matches • Page 1 of 1
- Sun May 19, 2019 9:36 pm
- Forum: Software - CAD, CAM, Workflow Help
- Topic: V Carve Software for XXL SO3 or something else?
- Replies: 6
- Views: 1848
Hello, I have just downloaded and started using a trial version of vectric software. Since it is a trial version I cannot save a toolpath and check the results on my Shapeoko 3 XL. I noticed that the listing for the Shapeoko put the *.gcode as the suffix on the toolpath. Is that how they are saved? ...
- Tue Mar 19, 2019 9:41 pm
- Forum: Discussion
- Topic: New wasteboard using v-slot extrusions
- Replies: 5
- Views: 3551
I just finished assembling my S3 XL a couple of weeks ago. I am about to surface level my supplemental mdf table. I had mapped the factory wasteboard. The factory wasteboard was about .03" higher on one end than the other. The front to back tolerances were pretty good - .004" variation. I noticed th...