Search found 107 matches

by dataway
Mon Feb 10, 2014 6:34 am
Forum: Discussion
Topic: Storing and using Shapeoko in a Chicago garage?
Replies: 2
Views: 875

Re: Storing and using Shapeoko in a Chicago garage?

I am using mine in my garage where if often gets in the teens in the winter and I also run a heater only when I am in there and I have not had any issues, I also have 3 computers in there and a 3D printer.
by dataway
Wed Jan 15, 2014 11:08 pm
Forum: Software - CAD, CAM, Workflow Help
Topic: Ventric Aspire 4
Replies: 6
Views: 1397

Re: Ventric Aspire 4

I just tried Intelicam GCode(mm) and it worked perfect, thanks Creaky for the info saved me a lot of time going through each post processor.
by dataway
Wed Jan 15, 2014 2:51 pm
Forum: Software - CAD, CAM, Workflow Help
Topic: Ventric Aspire 4
Replies: 6
Views: 1397

Re: Ventric Aspire 4

@Erlend

I am also attempting to figure out which post processor to use for my Shapeoko using GRBL. Were you able to figure this out?
by dataway
Thu Oct 10, 2013 9:01 pm
Forum: Discussion
Topic: Beta testers wanted
Replies: 13
Views: 2594

Re: Beta testers wanted

Count me in as a volunteer for the out of town project.....very cool
by dataway
Tue Oct 08, 2013 6:26 pm
Forum: Discussion
Topic: I found an excellent and inexpensive V bit
Replies: 17
Views: 4773

Re: I found an excellent and inexpensive V bit

Improbable construct,

Thanks, I see on your ETSY store you paddle and it has some writing engraved on it, was that done with that V bit ?

Paddle looks awesome by the way....very cool...
by dataway
Mon Oct 07, 2013 5:19 pm
Forum: Discussion
Topic: I found an excellent and inexpensive V bit
Replies: 17
Views: 4773

Re: I found an excellent and inexpensive V bit

Improbable Construct could you post a picture of the results you had with this Bit that would be much appreciated.

Regards,

John
by dataway
Fri Sep 27, 2013 5:20 pm
Forum: CAM Help
Topic: Cambam beginner question
Replies: 2
Views: 1116

Re: Cambam beginner question

What I do to change tools is find your home position then lower the spindle until it just touches the material then turn it on and lower it just a bit to make a mark then turn it off. That will be your zero mark for your tool change. Then in cambam I generate gcode for each tool then when a tool cha...