Search found 27 matches

by chambrot
Sat Dec 07, 2013 11:40 pm
Forum: Member Projects
Topic: First little project
Replies: 6
Views: 2010

Re: First little project

Its about 7" x 6.5" x .75"...took about 1.5 hours to cut. It was my first project and I didnt want to push it.
by chambrot
Fri Dec 06, 2013 10:15 pm
Forum: Member Projects
Topic: First little project
Replies: 6
Views: 2010

Re: First little project

Here is another better pic.
by chambrot
Fri Dec 06, 2013 9:14 pm
Forum: Member Projects
Topic: First little project
Replies: 6
Views: 2010

First little project

Well it was more of a test. My first cut on my ShapeOko! Super excited...can't wait to work on more stuff. Very happy that I went with ShapeOko over other machines. There is a nick at the bottom where the holding tab was...i got excited an pushed the piece thru...broke off a bit :roll: Let me know w...
by chambrot
Mon Nov 25, 2013 3:49 am
Forum: Assembly
Topic: Looking for BOM Shapeoko 2 with NEMA 23
Replies: 47
Views: 11473

Re: Looking for BOM Shapeoko 2 with NEMA 23

Oh ok, thanks for the info. I didn't really buy the kit, so there is no serial number. Been putting it together, with parts bought from inventables, local hardware stores, Amazon, ebay, and other online resources. I really liked the ShapeOko because it was upgradable and compared to other machines i...
by chambrot
Mon Nov 25, 2013 1:25 am
Forum: Assembly
Topic: Looking for BOM Shapeoko 2 with NEMA 23
Replies: 47
Views: 11473

Re: Looking for BOM Shapeoko 2 with NEMA 23

Hey IC, Thanks for your help, I tried moving the extrusions as far as they would go to the extreme ends and its very tight...but as i tried to make things fit i realized by the scratches oh the makerslide that I can just cut out some small notches to allow for the bolt to clear...it worked perfectly...
by chambrot
Sun Nov 24, 2013 10:07 pm
Forum: Assembly
Topic: Looking for BOM Shapeoko 2 with NEMA 23
Replies: 47
Views: 11473

Re: Looking for BOM Shapeoko 2 with NEMA 23

SideMotorMount.png Hello, Wondering if someone can confirm the use of M5 Screws, M5 Washers & M5 Hex nuts to attach a NEMA 23 to the motor mount plate... I am having trouble fitting the dual x makerslide between the 2 M5 screws. Can someone point my in the right direction? I have attached a drawing...
by chambrot
Fri Nov 08, 2013 7:24 pm
Forum: tinyG
Topic: TinyG Homing & Limit Switches
Replies: 1
Views: 1632

TinyG Homing & Limit Switches

Hello all,

Does anyone have or know where I can find a diagram or schematic on how to wire up the homing and limit switches to a TinyG? :?:

Thanks in advance.

J