The Shapeoko Forum

Just a box with a pocketing toolpath and you probably only need to go .02 depending on how unlevel your board is.

Mine is the XXL and it took 15-20 min if I remember right.

This is the one I use

https://www.amazon.com/gp/aw/d/B000P4O9 ... UTF8&psc=1

Here is another place I buy electronics parts from. They do have a bunch of Molex connectors. Dont know if they have the specific one you need but hopefully this helps.

http://www.newark.com/

Yes I had exactly that same problem. Contact Carbide Support and they will send you another switch. I recently switched to hall effect switches on all 3 axis both high and low. They are working great.

I have been buying most of my electronics equipment from these folks.

https://www.pololu.com/

It is the same plate they are putting on the new Shapeoko XL and XXLs.

It looks to me that your Z-axis is very loose. Check your eccentric nuts and make sure the v-wheels are snug on the lower part of the Y-rail and that when you move them they are able to slightly move the Z-axis on the Y-rail. Also it looks like your router is not square to your spoil board which is ...

No not at all, when I zero at the bottom of the stock everything works the way it should. I have been doing test cuts on different thickness of materiel and have had no problem with stock up to 1 inch thick. With that said, when I spoke with Apollo @ Carbide 3D they are very upset that Vetric has n...

I took the entire week off to build a CNC table for my new Shapeoko 3XXL. I researched several plans on the web and on CNC forums and found the assembly table that The Wood Whisperer built met the requirements I was looking for in a CNC table. 1. Dead flat top 2. Twist resistant top 3. Space for my ...