Search found 25 matches

by Bonch
Sun Jun 05, 2016 9:20 pm
Forum: Discussion
Topic: flat ground aluminum plate
Replies: 12
Views: 3288

Re: flat ground aluminum plate

https://www.midweststeelsupply.com/store/looks like a good place to purchase the plate reasonably priced.
by Bonch
Fri Jun 03, 2016 1:10 am
Forum: Electronics
Topic: Z axis went CRAZY?
Replies: 5
Views: 1192

Re: Z axis went CRAZY?

GRBL 0.8 c is what I have been using
by Bonch
Thu Jun 02, 2016 11:25 pm
Forum: Electronics
Topic: Z axis went CRAZY?
Replies: 5
Views: 1192

Re: Z axis went CRAZY?

The Shapeoko 3 post processor does crazy things to my machine. Power down everything and try using the GRBL 8 and see if you have better luck. Hope you get it fixed. It is annoying when things go haywire.
by Bonch
Thu Jun 02, 2016 11:10 pm
Forum: Electronics
Topic: Z axis went CRAZY?
Replies: 5
Views: 1192

Re: Z axis went CRAZY?

What post processor are you using in VCarve Pro. I had similar problems until i started using GRBL 8 as my post processor. You might want to try that if that is not what you are using.
by Bonch
Sat May 28, 2016 10:11 pm
Forum: For Sale
Topic: FS: Shapeoko 3 Limit Switch Kits - V2.0
Replies: 15
Views: 3731

Re: FS: Shapeoko 3 Limit Switch Kits - V2.0

Will these limit switches work with the Shapeoko 3 XXL. I received the homing kit as part of the purchase but was looking for something to make sure the machine stops slamming into the rails when something goes wrong. It has happened a couple of times and I am concerned that it will knock the machin...