Squaring z-Axis?

Post Reply
typomaniac
Posts: 64
Joined: Mon Oct 29, 2012 6:11 am
Location: Hamburg, Germany

Squaring z-Axis?

Post by typomaniac » Fri Oct 02, 2015 11:51 am

Hey all,

i just rebuilt my shapeoko (bigger!) and wanted to pay much more attention to squaring than before. This applies especially for the z-axis. I used a square to check the slides squareness in y-direction and recognized that it is not square at all. How do i adjust this? Is this a matter of the x-axis?

thank you!

tm
Proud owner of eShapeOko #17 :-) (Dual-X, Grbl 0.8a)

WillAdams
Posts: 8608
Joined: Mon Apr 09, 2012 6:11 pm
Location: Pennsylvania --- south of the Turnpike, East of US-15
Contact:

Re: Squaring z-Axis?

Post by WillAdams » Fri Oct 02, 2015 12:02 pm

Shapeoko 3XL #0006 w/ Carbide Compact Router w/0.125″ and ¼″ Carbide 3D precision collets

Post Reply