Simple & cheap clamping of workpieces

discussion of design changes / improvements / suggestions
johne64
Posts: 3
Joined: Sat Nov 28, 2020 3:53 pm

Re: Simple & cheap clamping of workpieces

Post by johne64 » Fri Dec 18, 2020 6:31 pm

For most pieces I use pin 23gauge pin nails of various lengths, 1/2,3/4 and 1 inch. They hold well and save come time. If I have thin material that bows I can find a place where it does not cut and secure it. If do hit a nail it does very little damage. Also use tongue depressors to raise the work piece up to get a good through cut of material.

Post Reply