GRBL Mount on side of Shapeoko

discussion of design changes / improvements / suggestions
Post Reply
Sprenkle
Posts: 18
Joined: Wed Jan 15, 2014 5:13 pm

GRBL Mount on side of Shapeoko

Post by Sprenkle » Thu Jul 03, 2014 2:23 am

I orginally attached my Arduino on the side of my Shapeoko with two sided velcro. Summer came and melted it away. So I came up with this. I attached it with tie wraps, pulling one through the holes and around the back and then putting a different tie wrap on the end of it and trimming it.
image (1).jpeg
image (1).jpeg (31.24 KiB) Viewed 958 times
image (2).jpeg
image (2).jpeg (33.18 KiB) Viewed 958 times
image (3).jpeg
image (3).jpeg (43.47 KiB) Viewed 958 times

Sprenkle
Posts: 18
Joined: Wed Jan 15, 2014 5:13 pm

Re: GRBL Mount on side of Shapeoko

Post by Sprenkle » Thu Jul 03, 2014 2:28 am

Here is one more photo and the file. I exported the file from Cambam so not sure how that will come out.
photo (2).JPG
photo (2).JPG (41.4 KiB) Viewed 954 times
Attachments
ShapeokoYunMount.dxf
(4.28 KiB) Downloaded 56 times

Post Reply