Improved dust collector

[hvalner]

I would love to get the files for this also. Really looking into a dust collector and this is ideal.

[bharbour]

I know! The dust boot I think I can design..but his pipe brackets are really cool. That area near the spindle has the potential to take up some of the X travel so you have to be careful I think.

I would love to get the files for this also. Really looking into a dust collector and this is ideal.

[FrancisChie]

Ok, since I feel generous today I'll shares all the STL files.

http://www.thingiverse.com/thing:696783

Sorry, after I have my dust collector working great I was so busy building and cutting other projects and rarely view this forum.

Hope this will help you guys. Enjoy your Shapeko 2!!

If inventibles give me the version 3 I will design again for you guys. hehe.

[FrancisChie]

I know! The dust boot I think I can design..but his pipe brackets are really cool. That area near the spindle has the potential to take up some of the X travel so you have to be careful I think.

I would love to get the files for this also. Really looking into a dust collector and this is ideal.

I considered the x travel on my design, if you look on the picture, the dust tube and the plate at the back is almost the same edge, you might just loose maybe 5mm x travel on the right but its worth it.

[bharbour]

I agree...worth it. I did finally see you had the files on Thingiverse...thanks for putting those out there!!!

I know! The dust boot I think I can design..but his pipe brackets are really cool. That area near the spindle has the potential to take up some of the X travel so you have to be careful I think.

I would love to get the files for this also. Really looking into a dust collector and this is ideal.

I considered the x travel on my design, if you look on the picture, the dust tube and the plate at the back is almost the same edge, you might just loose maybe 5mm x travel on the right but its worth it.

[BLAHBLAHBLAH]

Awesome work OP, And thanks for sharing the files.