New dust collector skirt material

discussion of design changes / improvements / suggestions
Post Reply
Woodworker
Posts: 639
Joined: Tue Mar 11, 2014 1:37 am
Location: 5 miles north of Benson, NC

New dust collector skirt material

Post by Woodworker » Tue Mar 24, 2015 11:58 pm

A little pricy but may make a good skirt.
http://www.fastcap.com/estore/pc/viewPr ... ategory=28
BRuce - SO2 #4798 - IC's Z axis upgrade, customized Z rail and Z motor mount, spindle Dewalt 611

Damin69
Posts: 331
Joined: Fri Oct 31, 2014 3:00 pm
Location: Muscoda, WI

Re: New dust collector skirt material

Post by Damin69 » Wed Mar 25, 2015 1:17 am

This material is a quite a bit cheaper. Probably does not bend as easy but for the price I can probably deal with it. http://www.mcmaster.com/#catalog/121/1296/=wged0l
Shapeoko 2 #6971
Upgrades
Makita 0701, Nema23s, ACME Z Axis, Nema 23 Belt drive
Expanded to 1000 x 1800
Electronics upgrade C-10 BOB, SainSmart ST-M5045 drivers, Mach3
Damin69's Build Log

Woodworker
Posts: 639
Joined: Tue Mar 11, 2014 1:37 am
Location: 5 miles north of Benson, NC

Re: New dust collector skirt material

Post by Woodworker » Wed Mar 25, 2015 9:46 am

Thank you, that is a great link. I agree, for the cost difference, it is worth it.
BRuce - SO2 #4798 - IC's Z axis upgrade, customized Z rail and Z motor mount, spindle Dewalt 611

Post Reply