I've made a few parts for my SO3.
The attached zips contains a Laserink saddle, Endstop/Limit switch fixtures, Drag chain fixtures, and a rear electronics cover.
My very sparse writeup is at:
http://laserink.forumchitchat.com/post/ ... o3-7535502
R,
Bob
Laserink saddle, endstops, dragchain adapters, rear cover
-
rkolbasowski
- Posts: 3
- Joined: Mon Aug 17, 2015 11:05 am
Laserink saddle, endstops, dragchain adapters, rear cover
- Attachments
-
- Drag-Chain-Adapter-upper.zip
- (106.8 KiB) Downloaded 122 times
-
- Drag-Chain-Adapter-lower.zip
- (123.97 KiB) Downloaded 97 times
-
- Cat5-DustCap.zip
- (110.52 KiB) Downloaded 89 times
-
rkolbasowski
- Posts: 3
- Joined: Mon Aug 17, 2015 11:05 am
Re: Laserink saddle, endstops, dragchain adapters, rear cove
Can only have three attachments per post...
- Attachments
-
- ES-Lower-2of2.zip
- (238.68 KiB) Downloaded 77 times
-
- ES-Lower-1of2.zip
- (232.84 KiB) Downloaded 92 times
-
- Electronics_Cover.zip
- (492.08 KiB) Downloaded 95 times
-
rkolbasowski
- Posts: 3
- Joined: Mon Aug 17, 2015 11:05 am
Re: Laserink saddle, endstops, dragchain adapters, rear cove
last three stl's.
- Attachments
-
- Laserink-Mount.zip
- (334.43 KiB) Downloaded 113 times
-
- ES-Z.zip
- (37.33 KiB) Downloaded 109 times
-
- ES-Upper-Set.zip
- (41.18 KiB) Downloaded 105 times