Another Dust Shoe

discussion of design changes / improvements / suggestions
Post Reply
atrueresistance
Posts: 151
Joined: Thu Feb 07, 2013 6:20 pm

Another Dust Shoe

Post by atrueresistance » Tue Feb 02, 2016 9:38 pm

This is based off a version from menerso.

Image

Image

Image

Image

Should take about 1hr 15minutes to mill out of 1/2" HDPE. The load for stress test was 5lbs. My idea was to drill spots for magnets and then magnetically attach the bristles below like Improbable Construct's.

What do you guys think?

------------------------
Update
------------------------
Tonight's progress
Last edited by atrueresistance on Wed Feb 03, 2016 3:46 am, edited 1 time in total.
Shapeoko 1 #unknown
Shapeoko 3 #572
Checkout my Etsy Store

Atonwa
Posts: 238
Joined: Tue Dec 30, 2014 2:54 pm
Location: Corning, NY

Re: Another Dust Shoe

Post by Atonwa » Tue Feb 02, 2016 10:35 pm

That looks great. For some reason I have been procrastinating making a dust shoe for mine. Do you plan to make those and sell or will you release the file? I'd much rather mill mine on my Shapeoko than 3D print one right now. I can never seem to find 3 hours to let it print.

Is the hose attachment for a 4" hose?
Shapeoko 3 #109
Routakit HD Beta #001

Post Reply