New controller board for CNC applications

sell your stuff here
Forum rules
Only legal items and items related to CNC projects are eligible to be advertised through this forum. if your item for sale is deemed to be not fit for the forum it will be removed without warning by one of the moderators.
Post Reply
T-Bone
Posts: 1
Joined: Sat Mar 22, 2014 5:32 pm
Location: Germany
Contact:

New controller board for CNC applications

Post by T-Bone » Sun Mar 23, 2014 12:52 pm

We just created a new controller board for CNC applications. The so-called T-Bone is a cape the BeagleBone Black and has a lot of unique features. Here some basic facts:
  • 5 stepper motor driver (run syncronized, 3 x up to 4 A, 2 x up to 1.5 A)
  • 10 inputs for end switches (two for each axis)
  • 3 inputs for incremental encoders (3 axis supporting closed loop control)
  • 3 inputs for thermistors
  • 1-wire interface for digital temp and other sensors
  • 2 high power outputs (for extruder and heatbed, up to 12 A)
  • 1 mid power output (for fans, LEDs, ..., also expandable)
  • Power supply for BeagleBone (5 V, 1.2A)
  • Input voltage 12 - 24 V
We also planning to release direct software support for the Shapeoko.

For more details see our project page: http://tbone.cc

We are currently running a crowdfundinhg campaign on Indiegogo to produce the first batch of hardware: http://igg.me/at/t-bone/x/4731310

All hard- and software components of the project will be released as open source.

Post Reply