shapeoko 2 with upgraded dremel

sell your stuff here
Forum rules
Only legal items and items related to CNC projects are eligible to be advertised through this forum. if your item for sale is deemed to be not fit for the forum it will be removed without warning by one of the moderators.
Halfdead
Posts: 47
Joined: Tue Nov 12, 2013 6:40 am

Re: shapeoko 2 with upgraded dremel

Post by Halfdead » Sun Oct 26, 2014 2:30 am

dave_the_nerd wrote:
DrDoktir wrote:Off the market. So, funny story, I bought this, had my friend pick it up, and then her mom ran it over. So i'll be updating with a repair build....
Umm...

:shock:
How does that even happen.

DrDoktir
Posts: 3
Joined: Fri Jul 04, 2014 7:01 pm

Re: shapeoko 2 with upgraded dremel

Post by DrDoktir » Thu Oct 30, 2014 10:29 pm

dave_the_nerd luckily she's a good friend and is helping me out. It looks like just the support on a corner is bent. I'm hoping it's just drilling a new plate and maybe getting anew piece of makerslide, but we'll see when it gets here. How can you be mad at moms?

DrDoktir
Posts: 3
Joined: Fri Jul 04, 2014 7:01 pm

Re: shapeoko 2 with upgraded dremel

Post by DrDoktir » Thu Nov 13, 2014 6:41 pm

OK, so it turns out that when a shapeoko gets run over, the rails can take it with minimal scratch, the end plates get destroyed. So i'm replacing the end plates and should be good to go!

Post Reply