Looking for Shapeoko - Charlotte Area

sell your stuff here
Forum rules
Only legal items and items related to CNC projects are eligible to be advertised through this forum. if your item for sale is deemed to be not fit for the forum it will be removed without warning by one of the moderators.
Post Reply
millsous
Posts: 2
Joined: Fri Mar 18, 2016 7:47 pm

Looking for Shapeoko - Charlotte Area

Post by millsous » Sat Mar 19, 2016 4:23 am

Located in Charlotte, NC. Looking for a Shapeoko 2 in N/C.

crashn_burn
Posts: 47
Joined: Wed Jun 19, 2013 2:54 pm

Re: Looking for Shapeoko - Charlotte Area

Post by crashn_burn » Wed Mar 30, 2016 11:32 am

not in NC but in DC, just a bit north. Are you looking to buy used?

Carl Fisher
Posts: 127
Joined: Fri Mar 07, 2014 1:36 pm

Re: Looking for Shapeoko - Charlotte Area

Post by Carl Fisher » Fri Apr 29, 2016 12:45 am

If you're still in the market, I'm in Fort Mill (just south of Charlotte) and I have a 1M x 1M upgraded SO2 that I have been thinking about parting with.

Several upgrades including Z-Axis upgrades with belt drive, Probotix Nema 23 motors all around, TinyG, 600W spindle (VS isn't working but works fine at full speed), drag chain, limit switches, etc... I've decided I'm better served with a 40W or 50W laser so the CNC is basically unused. Still needs a few tweaks to dial in the steps per rev and such but it's pretty close.

RaymondOverman
Posts: 50
Joined: Tue May 20, 2014 8:13 pm

Re: Looking for Shapeoko - Charlotte Area

Post by RaymondOverman » Fri Apr 29, 2016 2:48 pm

Carl,

I'm in FM also. Didn't realize any SO2 owners were so close.
SO2 / NEMA 23s / 5 axis SainSmart BOB and Drivers / DW660 Spindle / Rotary Axis / Spindle-Vac Relay / LimSW / Fender Wells / Drilled and Tapped 1"x8TPI Waste Board

Post Reply