tool path depth problems

Post Reply
aaronzo
Posts: 1
Joined: Fri Dec 21, 2018 8:15 am

tool path depth problems

Post by aaronzo » Sat Dec 22, 2018 12:44 am

Im using a small 30 / 15 eg per side v bit on 1/4" shank. Cutting only .010 " deep and the XXL machine is taking four passes to do this one cut.
I'm using Carb Create to set it up and Carb Motion to run it.
Can someone tell me why this might be happening? See attached tool setting. I'm trying o basically etch very thin lines into a wood surface.
Its taking far too long to run a simple pattern. This should all be done in one pass. How can I ensure this will happen?
Thanks

Aaron
Attachments
Screen Shot 2018-12-21 at 4.26.14 PM.png
Screen Shot 2018-12-21 at 4.26.14 PM.png (49.1 KiB) Viewed 154 times

Post Reply