MakerCan > Shapeoko3 units and sizing problem

DannyBoyNYC
Posts: 14
Joined: Sat Mar 07, 2015 5:16 pm
Location: Brooklyn

Re: MakerCan > Shapeoko3 units and sizing problem

Post by DannyBoyNYC » Sat Aug 01, 2015 2:16 am

Figured it out thanks to another post.

In case another newbie finds themselves in the same position - check your DIP switches on the controller board. Mine were set randomly and I had to set them all down and away from the 4 pin inputs.
Last edited by DannyBoyNYC on Sun Aug 02, 2015 3:55 pm, edited 1 time in total.

BellyUpFish
Posts: 174
Joined: Mon Jan 12, 2015 9:19 am

Re: MakerCan > Shapeoko3 units and sizing problem

Post by BellyUpFish » Sat Aug 01, 2015 2:56 pm

I finally got mine sorted out as well. I think the final number for X/Y was around 40.060, need to work on Z today.

Post Reply