### ShapeOko 3 do not reacts on Feed Speed

Posted:

**Thu May 04, 2017 3:36 pm**G-code generated with Inkscape.

Optimized manually with Camotics and Notepad ++

"4 slot test" (milling 4x 10mm slots with different feeding speeds: 1; 5; 10 and 20 mm per min)

showed that SO3 worked with a constant feed speed of 20 mm per min.

Can SO3 read G-Code Feed Speed Commands?

The example of code line:

Optimized manually with Camotics and Notepad ++

"4 slot test" (milling 4x 10mm slots with different feeding speeds: 1; 5; 10 and 20 mm per min)

showed that SO3 worked with a constant feed speed of 20 mm per min.

Can SO3 read G-Code Feed Speed Commands?

The example of code line:

*G00 Z 5.0000*

G00 X 0.0000 Y 0.0000

G00 X 0.0000 Y 0.0000

G00 Z 1.0000

G01 Z -5.0000

G01 X 0.0000 Y 10.0000 Z -5.0000

G00 Z 5.0000

G00 X 10.0000 Y 00.0000

G00 Z 1.0000

G01 Z -5.0000

G01 X 10.0000 Y 10.0000 Z -5.0000G00 X 0.0000 Y 0.0000

G00 X 0.0000 Y 0.0000

G00 Z 1.0000

G01 Z -5.0000

**F 1.0000**(Penetrate)G01 X 0.0000 Y 10.0000 Z -5.0000

G00 Z 5.0000

G00 X 10.0000 Y 00.0000

G00 Z 1.0000

G01 Z -5.0000

**F 5.0000**(Penetrate)G01 X 10.0000 Y 10.0000 Z -5.0000