Page 1 of 1

New forum for general milling (machine operation) issues

Posted: Mon Dec 03, 2012 10:16 am
by PsyKo
Hi folks,

I think a forum for general Shapeoko use issues would be good. As a personnal example, I have some error in the machined dimension, and I don't know where that come from. I can't post in assembly, or electronic or even spindle, since I'm not sure. Besides it's not a project, so not in Member project.

Thanks

Re: New forum for general milling (machine operation) issues

Posted: Mon Dec 03, 2012 12:13 pm
by edwardrford
That's a good idea. I'll put up a new forum for that an post a link back here when it's open for business.

-Edward

Re: New forum for general milling (machine operation) issues

Posted: Mon Dec 03, 2012 1:13 pm
by PsyKo
Thanks ;)