Section for projects?

Have a suggestion for the website or forum? Post it here.
Post Reply
Posts: 80
Joined: Tue Apr 10, 2012 11:09 pm
Location: Chicago, IL

Section for projects?

Post by jsbannis » Wed May 16, 2012 11:04 pm

It seems like the one of the coolest parts of a community like this is seeing all the stuff that other people have done. I know when I used to frequent the BYOAC forum I was mildly addicted to seeing others' shiny creations.

I'm not quite clear on the purpose of the "Build Logs" section, but it seems like, at least for a while, it will mostly be full of Shapeoko build-ups and improvements. I'm all for that, but it might be beneficial to have separate sections for "Look I built/improved my Shapeoko!" and "Look what I made with my Shapeoko!".

Not saying it should definitely be added, because there's also the balance of cluttering up the main page, but might be worth discussion.
shapeoko #0057

Posts: 94
Joined: Mon Apr 09, 2012 9:32 pm
Location: Central Texas

Re: Section for projects?

Post by DevinTX » Thu May 17, 2012 12:27 am

While I am waiting for the delivery of my machine I can only double check my wire plugs so many times. I too would very much like to see some of the projects others have done.

I think its a great idea

ShapeOko # 207 / Dual Y Drive / Acme Upgrade / Belt on outside / Working on expansion

Burke LaShell
Posts: 90
Joined: Tue Apr 10, 2012 12:42 pm
Location: Philadelphia, PA

Re: Section for projects?

Post by Burke LaShell » Thu May 17, 2012 1:39 am

Good idea!

There have been a few things posted. In the wiki, there were a couple belt anchor improvements. ... mentations

Here's my wonderful 3 inch box :roll:

If I get a little cooperation from PhlatScript, I'll post my new pen holder.

Post Reply