Is it just me or is this website always really slow to load? Sometimes I can wait a good 30 seconds for it to fully load.
EDIT: Of course after I post this everything loads basically instantly, I wonder if they upgraded the service again?
EDIT: Took 15 seconds to load a page this time, something is wrong...
Website Loading Slow
-
- Posts: 199
- Joined: Mon Dec 16, 2013 2:09 pm
- Location: Ohio
- Contact:
Re: Website Loading Slow
HalfDead,
Your not the only one seeing this. I've tried the site on 3 different devices On 3 different ISPs All with the same latency issues. Ranges from 15 to 30 seconds irrespective of the time of day.
Thanks,
CBB
Your not the only one seeing this. I've tried the site on 3 different devices On 3 different ISPs All with the same latency issues. Ranges from 15 to 30 seconds irrespective of the time of day.
Thanks,
CBB
Re: Website Loading Slow
I have a similar experience with the site. I have a feeling it's being run off an extra arduino from the shapeoko parts inventory. 

ShapeOko #1728. 1000mm dual drive y, 500 mm double x, Acme Z, V2 motor plates, DW 660.
Re: Website Loading Slow
It's slow for me too. I've seen this type of behavior before, when the site was doing a host name lookup for each client IP address, and many of them failed. (I'm not saying that's what this is, but it would explain why some people with otherwise good network connections see the problem while others don't.)
Proud owner of ShapeOko #709, eShapeOko #0, and of store.amberspyglass.co.uk
Re: Website Loading Slow
Custom pages seem significantly slower, e.g. new posts since your last visit.
Re: Website Loading Slow
Yeah, I don't know what is causing it, but it needs to be fixed.
Re: Website Loading Slow
I'm having the same issue, drives me nuts!
Brian
Shapeoko 2 #I have no idea
HF cutout tool, 72oz nema 17 steppers, TB6600 stepper drivers, Mach3 control
Shapeoko 2 #I have no idea
HF cutout tool, 72oz nema 17 steppers, TB6600 stepper drivers, Mach3 control