Vectric Aspire Post processor for Laser engraving

Post Reply
rsieders
Posts: 12
Joined: Thu Jan 22, 2015 4:11 pm

Vectric Aspire Post processor for Laser engraving

Post by rsieders » Fri Jun 12, 2015 2:38 pm

Hi Everyone,

Figured someone else may get some use out of this as well. I have set up a post processor for Vectric aspire to generate the gcode for my shapeoko. It basically just removes the Z axis movements for the gcode and replaces them with S0 to set the laser intensity to 0 during rapid moves.
Attachments
Shapeoko_Laser.zip
(891 Bytes) Downloaded 485 times

Post Reply