Speeds and Feeds for Vinyl Drag Knife Cutting

Post Reply
SamSpade
Posts: 1
Joined: Wed Feb 21, 2018 1:55 am

Speeds and Feeds for Vinyl Drag Knife Cutting

Post by SamSpade » Sat Apr 28, 2018 3:48 pm

I purchased a 1/4" drag knife bit and I'm not sure what settings to enter into Carbide Create for: DOC, Feed, Step over and Plunge? I'm using 2.8ml vinyl.
I assume the DOC would be the thickness of the vinyl. Any help would be appreciated.
“My way of learning is to heave a wild and unpredictable monkey-wrench into the machinery.”

Post Reply