Machinkit

Discussion of linuxCNC (formerly knows as EMC2)
Post Reply
samc99us
Posts: 269
Joined: Mon Nov 11, 2013 5:20 pm

Machinkit

Post by samc99us » Wed Feb 10, 2016 11:06 pm

Looks like there is serious progress. Anyone using?

I just noticed this integrated setup that looks ready to go, I inquired on price: http://www.thecooltool.com/en/accessori ... /sandybox/

It would be nice to be fanless: http://blog.machinekit.io/p/hardware-capes.html
Modified Shapeoko 2: 1500mm fully supported y-axis, 1000 mm 4060 x-axis, ACME Belt Drive Z-axis, Dewalt DNP611, full aluminum t-slot table, 4x NEMA23 180 oz/in stepper motors driven by a G540

Post Reply