TinyG Configuration

Discussion of tinyG control platform
Post Reply
routerboiz
Posts: 1
Joined: Mon May 15, 2017 3:29 pm

TinyG Configuration

Post by routerboiz » Mon May 15, 2017 3:51 pm

Hi, I am a high school student in an Engineering class. My group and I are building a CNC Router out of a TinyG, 3 NEMA 23 Motors, and a spindle speed controller. We have got our motors running on jog mode through the Universal G-Code Sender, but we cannot figure out how to send codes to the TinyG through either the Universal G-Code Sender or through Coolterm. We have tried to send $100, $101, and $102 GRBL codes to edit the steps/mm, but we have never successfully sent the codes. We have also tried other codes to tune our motors, but neither our group nor our teacher can figure out what codes to send, or where to send them. If you have any ideas, please send them our way! Thanks.

LTEPM
Posts: 271
Joined: Tue Jan 06, 2015 4:34 am
Location: no where near the end of the rainbow

Re: TinyG Configuration

Post by LTEPM » Tue May 16, 2017 4:15 am

Have you tried Chilipeppr for tiny G?

When you send the commands in terminal mode how are you sending?

Are you able to view all the settings with $$ command?

Post Reply