grblshield along with AutoLeveller - possible?

Post Reply
Johan_vV
Posts: 1
Joined: Fri Jun 06, 2014 8:01 am

grblshield along with AutoLeveller - possible?

Post by Johan_vV » Fri Jun 06, 2014 10:50 pm

Hi,

I have tried finding information about how running the AutoLeveller software for PCB height probing along with the grblshield on my Shapeoko. The only real tutorials I can find is made for Mach3 or LinuxCnc. I have found some discussions here in this forum about using AutoLeveller for better PCB milling, but not any info on how to get it working on a grbl.

So, is there any one who knows how or if it is possible to run the AutoLeveller software with the grblshield?

Thanks in advance
//Johan

cvoinescu
Posts: 4442
Joined: Thu Jul 19, 2012 6:50 pm
Location: Camberley, UK
Contact:

Re: grblshield along with AutoLeveller - possible?

Post by cvoinescu » Sat Jun 07, 2014 12:01 am

GRBL 0.9e supports probing, but I don't know whether it's the same type used by the specific auto-leveller software you want to use. I think it should work, but that's just a guess. If you get them to work together, let us know!
Proud owner of ShapeOko #709, eShapeOko #0, and of store.amberspyglass.co.uk

jlauer
Posts: 115
Joined: Thu Jun 26, 2014 9:29 pm

Re: grblshield along with AutoLeveller - possible?

Post by jlauer » Fri Jul 11, 2014 4:16 pm

If you've got a TinyG controller, check out this forum post.

http://www.shapeoko.com/forum/viewtopic.php?f=28&t=3797

Post Reply