Which projects besides Shapeoko also use GRBL?

Discussion about the arduino based g-code interpreter, grbl
Post Reply
tioJim
Posts: 135
Joined: Sun Apr 22, 2012 11:31 am

Which projects besides Shapeoko also use GRBL?

Post by tioJim » Mon May 27, 2013 11:01 am

As title!

PsyKo
Posts: 430
Joined: Thu Aug 30, 2012 8:42 pm
Location: France

Re: Which projects besides Shapeoko also use GRBL?

Post by PsyKo » Mon May 27, 2013 11:18 am

Shapeoko #736
Kress 800, Z Axis upgrade, dual Y, 600mm X&Y rails, metal spacers and V Wheels, home switches, 4th axis
Goko - Free CNC Control Software - http://www.shapeoko.com/forum/viewtopic ... 380#p44380

ejs
Posts: 84
Joined: Sat Apr 28, 2012 7:42 pm
Location: Pittsburgh, PA, USA
Contact:

Re: Which projects besides Shapeoko also use GRBL?

Post by ejs » Thu Jul 04, 2013 10:47 pm

I think it's worth noting that GRBL and Sprinter were used together as the seeds of at least on of the standard RepRep firmware projects, though I don't recall which.
GRBL has also been extended and is what driver the very, very cool Lasersaur OSHW project. It is known as LasaurGrbl and has all kinds of extra interfaces that are built for lasing and safety http://labs.nortd.com/lasersaur/manual/driveboard.
Build it better than it was built for you. And give permission for the next guy to do the same. That's how Open Source works.
ShapeOko # 497: http://bit.ly/reactshop producing the Buildlog CNC Stepper Shield

cvoinescu
Posts: 4442
Joined: Thu Jul 19, 2012 6:50 pm
Location: Camberley, UK
Contact:

Re: Which projects besides Shapeoko also use GRBL?

Post by cvoinescu » Thu Jul 04, 2013 10:57 pm

ejs wrote:I think it's worth noting that GRBL and Sprinter were used together as the seeds of at least on of the standard RepRep firmware projects, though I don't recall which.
That would be Marlin.

People use GRBL for anything with up to three steppers. For example: camera sliders, vending machines, jukeboxes.
Proud owner of ShapeOko #709, eShapeOko #0, and of store.amberspyglass.co.uk

Post Reply