Page 1 of 1

Mini Amp Enclosure

Posted: Sun Sep 04, 2016 10:43 pm
by Damin69
So My Brother in law got me an amp for Xmas. I just opened it about a month ago and have been playing with it. I just decided it needed in enclosure so I made one for it out of Oak. I had salvaged some pallet wood and come up with a couple of nice pieces of oak to use. I did my basic layout in autoCad then brought into CamBam to cut out on the CNC. Here is how it turned out.

Image
Image
Image
Image
Image

Re: Mini Amp Enclosure

Posted: Mon Sep 05, 2016 2:58 pm
by hatallica
There is elegance in simplicity - nice looking home for the amp.

Is it press-fit only? I did not see any form of fastener or adhesive.

Re: Mini Amp Enclosure

Posted: Mon Sep 05, 2016 3:02 pm
by Damin69
hatallica wrote:There is elegance in simplicity - nice looking home for the amp.

Is it press-fit only? I did not see any form of fastener or adhesive.
The front bottom and back are all glued into a dado cut. The top plate has a full sliding dado so the top will just slide off to access the board. Simple but effective.

Re: Mini Amp Enclosure

Posted: Tue Sep 06, 2016 4:46 pm
by JeromyReno
this is awesome. im making a similar one i hope to have pictures of it up soon.