Newbie on Mach3 and Chinese controller

Discussion of Mach3 CNC control software
nio
Posts: 115
Joined: Mon Apr 09, 2012 7:31 pm

Re: Newbie on Mach3 and Chinese controller

Post by nio » Thu Feb 14, 2013 9:22 am

The problem is the laptop parallel port!!
i just test it a desktop computer with parallel port and works well, so now i've other problem, find a old desktop computer and put it with the spapeoko and its new dimensions, i've not free space :?...

Thanks IC for your time...

nio
Posts: 115
Joined: Mon Apr 09, 2012 7:31 pm

Re: Newbie on Mach3 and Chinese controller

Post by nio » Thu Feb 14, 2013 10:56 am

Improbable Construct wrote:Oh I might see your problem
my steps per with 16x microstepping is 87.48906387
have you 200 steps/rev motor??

Post Reply