So I'm now wiring my limit switches following the schematic on the CNC4PC website. I have attached it. Can someone tell me what settings in Mach 3 I need to use?
Revised: ok I figured it out.
Limit switch wiring question
-
- Posts: 168
- Joined: Tue Oct 07, 2014 4:16 pm
Limit switch wiring question
- Attachments
-
- image.jpg (116.17 KiB) Viewed 1945 times
Re: Limit switch wiring question
I have not connected mine up yet. That I hope to get to in the next few weeks. I a bit of my project has been side tracked for the past couple of weeks. This is basically what I am planing on doing with my switches. Have you started a build log yet? Would love to see the progress you have made on your machine.....
Shapeoko 2 #6971
Upgrades
Makita 0701, Nema23s, ACME Z Axis, Nema 23 Belt drive
Expanded to 1000 x 1800
Electronics upgrade C-10 BOB, SainSmart ST-M5045 drivers, Mach3
Damin69's Build Log
Upgrades
Makita 0701, Nema23s, ACME Z Axis, Nema 23 Belt drive
Expanded to 1000 x 1800
Electronics upgrade C-10 BOB, SainSmart ST-M5045 drivers, Mach3
Damin69's Build Log
-
- Posts: 168
- Joined: Tue Oct 07, 2014 4:16 pm
Re: Limit switch wiring question
Damin69 wrote:I have not connected mine up yet. That I hope to get to in the next few weeks. I a bit of my project has been side tracked for the past couple of weeks. This is basically what I am planing on doing with my switches. Have you started a build log yet? Would love to see the progress you have made on your machine.....
Well I finally got them sorted out and working. Just needed to get the settings in Mach 3 configured right. Now I'm trying to get the dual Y axis steppers to home simultaneously.
Haven't started a build log yet but I really need to.