Advice on carving image

General Discussion about anything!
Post Reply
Posts: 42
Joined: Sat Jun 29, 2019 9:17 pm

Advice on carving image

Post by Lookin4help » Tue Jun 30, 2020 6:28 pm

I want to cut an image using a 30 V carve bit. When I run this in simulation mode 95% of it looks ok, but the rest not so good. I am hoping that someone else might run this in simulation mode and offer some advice on how to clean this up. You will note in particular at the bottom of the image there is a sleeve cuff that looks frayed, and there are a few other places that have the same look. I wish it were possible to attach the .c2d file, but alas it isn't possible.

If you've any advice, thanks in advance.

(909.92 KiB) Downloaded 22 times

Post Reply