Great deal on double-sided foam tape

General Discussion about anything!
Post Reply
Brian Stone
Posts: 295
Joined: Tue Oct 21, 2014 1:52 am
Location: Seattle, WA

Great deal on double-sided foam tape

Post by Brian Stone » Wed May 27, 2015 2:11 am

I've grown very fond of double-sided foam tape to hold down pieces of stock that are too small or awkward to be clamped. I've been able to cut some very small and delicate parts using this stuff, sometimes avoiding the need of tiny parting tabs that would have been difficult to remove later.

So, I jumped on this deal for 55 Yards of 3/4" wide foam tape for about $20USD. --> ... TE_3p_dp_1

If you like this stuff as much as I do, just a word of caution about this particular product -- It doesn't appear to be the 3M brand, but some knockoff instead. It is slightly less sticky than the 3M stuff, but it still holds well, and it is thinner at about 1.1mm, versus 1.5mm for the 3M brand. Regardless, it looks like it's going to work very well for me and what I use it for.
20150526_183649.jpg (10.97 KiB) Viewed 1021 times
That's a lot of tape!

Shapeoko 2 #7353
1500x1000mm Shapeoko/X-Carve Hybrid, Nema-23's, Belt-Driven Z-Axis /w ACME Screw, Dewalt 611, Soundproof Enclosure
[Fusion 360 | Illustrator] -> Universal G-Code Sender

Ing Chao
Posts: 72
Joined: Fri Dec 28, 2012 7:10 pm

Re: Great deal on double-sided foam tape

Post by Ing Chao » Sun May 31, 2015 12:18 am

LOL, great pic!!! :lol: :lol:
Yes, that's a lot of tape for sure! Thanks for posting, I gotta get me some.
'Oko #1153- D Extended Y axis-1000mm. Dual X axis makerslide-900mm Nema 23 X and Y axis motors. Arduino Uno and Grbl shield controller running on 24v.

Posts: 61
Joined: Mon Apr 20, 2015 12:22 am

Re: Great deal on double-sided foam tape

Post by GoSpeedRacer » Sun May 31, 2015 1:22 am

I use 3m double-sided tape with my pin router and planned to use it when I make the cnc jump too. That's a fantastic deal, I'll have to jump on it too!

Post Reply