F Engraved

General Discussion about anything!
Post Reply
Posts: 1
Joined: Thu May 03, 2018 6:10 pm

F Engraved

Post by Rchris » Thu May 03, 2018 9:36 pm

Hey guys I am really new to C&C routing . So my question is ? When I use f engrave. The Z axis comes down very slow it moves up fast So if somebody has had this problem or know what setting I need to change I would greatly appreciate it Thank you for your time

Posts: 8608
Joined: Mon Apr 09, 2012 6:11 pm
Location: Pennsylvania --- south of the Turnpike, East of US-15

Re: F Engraved

Post by WillAdams » Fri May 04, 2018 1:29 pm

That should be set by the safety / retract height and your plunge rate --- the latter needs to be slow so as to not deflect when entering the material or going lower.
Shapeoko 3XL #0006 w/ Carbide Compact Router w/0.125″ and ¼″ Carbide 3D precision collets

Post Reply