The Shapeoko Forum

Posted: **Wed Feb 20, 2013 10:14 pm**

It looks like my dimensions change when I go from inkscape to makercam? I drew my part in inkscape with a width of 4" and height of 2.25" ish. When you load it into makercam, it changes the dims to a 5" wide and a height of 2.75" ish?

Anyone else have that issue?

Posted: **Thu Feb 21, 2013 9:04 pm**

Be sure to change the import settings in makercam when you import from inkscape SVG.

Goto Edit -> Edit Preferences -> change the top value from 72 to 90.

That'll fix it.

-Edward

Posted: **Thu Feb 21, 2013 9:21 pm**

That is what I was looking for, thanks!

The Shapeoko Forum

Inkscape to makercam dims off? - Change the preferences!

Inkscape to makercam dims off? - Change the preferences!

Re: Inkscape to makercam dims off?

Re: Inkscape to makercam dims off?