TB6600 HY-DIV268N-5A with Mach3

Discussion of the TB6560 type stepper driver boards.
Post Reply
jameslee522
Posts: 20
Joined: Fri Nov 07, 2014 1:01 am
Location: Tulsa, OK

TB6600 HY-DIV268N-5A with Mach3

Post by jameslee522 » Fri May 01, 2015 7:51 pm

I wanted to share my settings for the TB6600 HY-DIV268N-5A since I couldn't find any info while setting these up with the shapeoko.

I have mind setup like this

X & Y 268oz nema 23 steppers

1Off 2Off 3OFF 4ON 5OFF 6OFF

This should be 5a (not really 5a but moving on) at 1/16

Z setup at nema 17
1OFF 2OFF 3ON 4OFF 5ON 6OFF

This should be 1.8a at 1/8

This is what I have for mach motor tuning settings
X and Y
Steps per Inch 2028.91839
Velocity 180
Acceleration 50
G's 0.1295095

Z
Steps per Inch 32461.34937
Velocity 18.762
Acceleration 5.9355204
G's 0.015374

These are the settings I have been using. If anyone has any advice on making anything better let me know.

Here is a short video of my shapeoko cutting some 1/8 aluminum. Not sure of the grade.

Post Reply