mach3 spidle control

Get help with the Geckodrive motor controller
Post Reply
Posts: 38
Joined: Mon Dec 09, 2013 7:49 pm

mach3 spidle control

Post by thebenj » Sun May 17, 2015 7:04 pm

i have a Chinese spindle with a power supply that can be controlled via g-code.

this one : ... EBIDX%3AIT

can anyone help with where to connect the 5v pwm on to the geckog540 or is it only for the Chinese boards? i will be using mach3

cheers :D

Posts: 88
Joined: Mon Jun 09, 2014 1:43 pm

Re: mach3 spidle control

Post by lioramsalem » Thu May 28, 2015 8:37 am

Just wire the gecko g540 terminals the same way the potentiometer is wired...

It worked for me...
ShapeOko 2 #5840 w/ NEMA23, ACME Z axe belt upgrade, limit switches, spindle speed control, 400w brushless spindle, 9mm belts, aluminum bed, eShapeoko X carriage and belts system

Build log:

Post Reply